3D printed RC car controlled with a Arduino microcontroller and Bluetooth.
Here is the list of electronics that I plan to use in this project:- 1 Raspberry Pi (Raspberry Pi 4 Model B)
- 1 DC motor (JIARUIXIN RS550)
- 2 Servo motor (sg90)
- 1 DC motor controller (don't have one, so I will use 1 relay instead)
- 1 Step-down voltage regulator 6V (Maestro D24V150F6)
- 8 bearings ((8mm x 22mm x 7mm))
The Raspberry Pi's GPIO pins will be programmed in Python, receiving commands from the command line using PHP.