Add WHY2025 target (unsupported)

Makefile

@@ -42,6 +42,8 @@ else ifeq ($(DEVICE), esp32-p4-function-ev-board)
 IDF_TARGET ?= esp32p4
 else ifeq ($(DEVICE), esp32-s31-korvo-1)
 IDF_TARGET ?= esp32s31
+else ifeq ($(DEVICE), why2025)
+IDF_TARGET ?= esp32p4
 else
 $(warning "Unknown device, defaulting to ESP32")
 IDF_TARGET ?= esp32

sdkconfigs/why2025

@@ -0,0 +1,71 @@
+CONFIG_IDF_TARGET="esp32p4"
+CONFIG_BSP_TARGET_WHY2025=y
+CONFIG_ESPTOOLPY_FLASHMODE_QIO=y
+CONFIG_ESPTOOLPY_FLASHSIZE_16MB=y
+CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partition_tables/esp32p4-16mb.csv"
+CONFIG_SPIRAM=y
+CONFIG_SPIRAM_SPEED_200M=y
+CONFIG_IDF_EXPERIMENTAL_FEATURES=y
+CONFIG_BT_ENABLED=y
+CONFIG_BT_NIMBLE_ENABLED=y
+CONFIG_BT_NIMBLE_TRANSPORT_UART=n
+CONFIG_ESP_WIFI_IRAM_OPT=y
+CONFIG_ESP_WIFI_RX_IRAM_OPT=y
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_CMD_SLOT_1=33
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_CLK_SLOT_1=32
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D0_SLOT_1=28
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D1_4BIT_BUS_SLOT_1=31
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D2_4BIT_BUS_SLOT_1=30
+CONFIG_ESP_HOSTED_PRIV_SDIO_PIN_D3_4BIT_BUS_SLOT_1=29
+CONFIG_ESP_HOSTED_SDIO_RESET_SLAVE_USING_CALLBACK=y
+CONFIG_ESP_HOSTED_SLAVE_RESET_ONLY_IF_NECESSARY=y
+CONFIG_ESP_HOSTED_HOST_RESTART_NO_COMMUNICATION_WITH_SLAVE=n
+CONFIG_ESP_HOSTED_ENABLE_BT_NIMBLE=y
+CONFIG_SLAVE_IDF_TARGET_ESP32C6=y
+CONFIG_TINYUSB_RHPORT_FS=y
+CONFIG_TINYUSB_VENDOR_COUNT=1
+CONFIG_CUSTOM_CA_TANMATSU_APPS=y
+CONFIG_CUSTOM_CA_TANMATSU_OTA=y
+CONFIG_LCD_DSI_ISR_IRAM_SAFE=y
+CONFIG_SPIRAM_MALLOC_RESERVE_INTERNAL=65536
+CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG=y
+CONFIG_PM_ENABLE=y
+CONFIG_PM_DFS_INIT_AUTO=y
+CONFIG_FATFS_VOLUME_COUNT=3
+CONFIG_FATFS_VFS_FSTAT_BLKSIZE=8192
+CONFIG_FATFS_USE_FASTSEEK=y
+CONFIG_FATFS_FAST_SEEK_BUFFER_SIZE=64
+CONFIG_FATFS_ALLOC_PREFER_EXTRAM=n
+CONFIG_SPI_FLASH_SUPPORT_WINBOND_CHIP=y
+CONFIG_USB_HOST_HUBS_SUPPORTED=y
+CONFIG_BOOTLOADER_REGION_PROTECTION_ENABLE=n
+CONFIG_FATFS_USE_FASTOPEN=y
+CONFIG_FATFS_MAX_FILES_OPEN=8
+CONFIG_FATFS_STDIO_BUF_SIZE=8192
+CONFIG_BADGELINK_QUEUE_SIZE=256
+CONFIG_SPIRAM_PRE_CONFIGURE_MEMORY_PROTECTION=n
+CONFIG_ENABLE_LAUNCHERPLUGINS=y
+CONFIG_ENABLE_AUDIOMIXER=y
+CONFIG_TINYUSB_MSC_ENABLED=y
+CONFIG_TINYUSB_RHPORT_FS=y
+# Build for ESP32P4, not ESP32P4X
+CONFIG_ESP32P4_SELECTS_REV_LESS_V3=y
+CONFIG_ESP32P4_REV_MIN_1=y
+CONFIG_ESP32P4_REV_MIN_FULL=1
+CONFIG_ESP_REV_MIN_FULL=1
+# Statistics
+CONFIG_FREERTOS_GENERATE_RUN_TIME_STATS=y
+CONFIG_FREERTOS_USE_TICKLESS_IDLE=y
+
+#SerialOutput
+CONFIG_ESP_CONSOLE_UART_DEFAULT=y
+CONFIG_ESP_CONSOLE_SECONDARY_NONE=y
+CONFIG_ESP_CONSOLE_UART=y
+CONFIG_ESP_CONSOLE_UART_NUM=0
+CONFIG_ESP_CONSOLE_ROM_SERIAL_PORT_NUM=0
+CONFIG_ESP_CONSOLE_UART_BAUDRATE=115200
+
+#Why2025 hardware mods
+CONFIG_BSP_WHY2025_AUDIOREMAPED=n
+CONFIG_BSP_WHY2025_JTAG=n
+