Feature Requests!

[remmob]

If you have a feature request, you can submit it here. Please start a new thread for each separate request.

[RalfvV]

add state of pump P1 and P2 (would be interesting to know when these are turned on/off)

[remmob]

Look for the entities P1 Heating, P1 cooling and same for P2. The are already there.

[RalfvV]

I have seen these values too, but those seem to represent setting M11.06, M11.07, M11.09 and M11.10. These are not the actual relay positions that turn on/off P1 and P2 pump

[remmob]

You have a load connected to them?
The probably do not switch without load.
I have not a pump connected to these terminals.

[tmbreuker]

Now summer has started, would it be possible to implement a function to write cooling settings via this integration? I don't know the menu but in HA the config names are: Amber coolcurve 1, Amber coolcurve 1 setpoint 1 to 3 en coolcurve outside temperature 1 to 3. Currently, these are read only.

[remmob]

Unfortunately that is not possible, Itho didn't made these settings writeable.

I haved checked all settings, those that are writeable.
Are also writeable in the integration.

I have been asking them since the release, for all settings to be made writeable.

[tmbreuker]

apologies, could and should have check tweakers first. You already mentioned this 2 yrs ago: https://gathering.tweakers.net/forum/list_message/78556814#78556814