No display

[Mobboss1]

I have tried and tried to get the display to show the time.
The data uploads to seeed with bluetooth working in uart and the tone chimes but no data on display

[Yanning026]

same issue, bluetooth working but no data on display, did you figure out?

[Gero028]

Pareil !! Même soucis pas d'affichage !!!

[Mobboss1]

same issue, bluetooth working but no data on display, did you figure out?

To get the display to work, first you have to change over the bridge on your temp sensor.
There are 3 solder tabs near the sensor. One side is already bridged.
Cut the bridge and solder the opposite side.
Good luck.

[Mobboss1]

No code needs to be changed. Looking at the BME280 sensor image. The three solder pads, from new the top pad is currently connected. Disconnect this pad by cutting the pcb trace and solder the bottom two together. Once this achieved, the display will illuminate.

[Mobboss1]

The modification image is correct