Detection Length setting changes and doesn't respond to detected movement.

[jensen005]

Setup the sensor and everything was working as expected for weeks. Recently, I had a bunch of false triggers and have determined the following:

• Randomly, the detection length changes from the set 15mm to 22mm
• When this happens, the plugin still shows Filament is Moving: Yes
• The Remaining distance then counts down from 22 to 0 and then triggers a pause.
• If you restart the print, it again just counts down from 22 and pauses right away.
• Connection testing is successful at showing filament moving.
• If you reset the distance to 15 and save it, the sensor returns to normal operation for a time.
• Rebooting the Pi did not prevent the issue from recurring.
• Removing and Reinstalling the plugin did not prevent the issue from recurring.

Any help would be appreciated, I've disabled the sensor to prevent delays in long prints but would like to get it running again.

[wrathernaut]

Detection distance seems to operate the same whether there is filament actually going through the sensor or not for me.

[Royrdan]

Mine does exactly the same thing. But sometimes it goes to 127mm length then just counts down

[wrathernaut]

I've had it work as intended after switching the distance to 7mm. Nothing else send to work.