Hi, I am writing- and I don't know if this project is dead or not so no worries if it is not supported. - I am building a DLP printer. I had it working on nanoDLP - but need to switch programs to be able to review what is happening on the printer. I came upon photonic, and installed. I have everything running except it would connect or does not understand the projector model. Is there any possibility you might be able to help?
mUVe printer
RasPi4
Optoma UHD60 (4k)
Arduino/Mega 2560
Marlin V2.0 (have 1.0 too if that is needed)
DL from https://github.com/area515/Photonic3D
Thanks,
Elliot
Hi, I am writing- and I don't know if this project is dead or not so no worries if it is not supported. - I am building a DLP printer. I had it working on nanoDLP - but need to switch programs to be able to review what is happening on the printer. I came upon photonic, and installed. I have everything running except it would connect or does not understand the projector model. Is there any possibility you might be able to help?
mUVe printer
RasPi4
Optoma UHD60 (4k)
Arduino/Mega 2560
Marlin V2.0 (have 1.0 too if that is needed)
DL from https://github.com/area515/Photonic3D
Thanks,
Elliot