won't calibrate

[hoopty1]

Hey Nick.

Might have been overpowering the bluetooth. I don't know but that part is working now.

New problem I cannot get it to calibrate. I am sending a screenshot since I am not sure why it won't accept it

[hdonk]

Hi
I'd suggest doing a manual calibration.
Get the board set up as you have here in the calibration, then go in to the scan screen.
In the can screen, use the Laser start position & Laser test to find out where the laser just touches the left hand side of the top left black spot, and the left hand side of the top right black spot. Write them down for when the config file becomes incompatible :) Then enter them in the config screen in the Detection angle left and the Detection angle right boxes.