Initial layer factor not showing up, if all the other factors are the same.

[aLECChe]

Thank you very much for this great plugin.

I use this plugin mostly to disable LA for the first layer. But it seems if I only set the Initial Layer Linear Advance Factor to 0. Nothing would happen.

There is only ONE line of M900 in the sliced G code file.

But if I changed any one of the other Factors in Cura, it seems the problem is gone.

There are multiple M900, with the M900 K0 just before the first layer.

I am wondering, is this a problem ? or did I miss something on the correct usage ?

Thank you once again!

[shyblower]

I also just stumbled over this issue

[aLECChe]

my temporary solution is to use very similar value in other factors. something like:

wall factor: 0.55
top/ bottom: 0.54
initial layer: 0