[BUG] Filament Loader Runs Backwards When Trying to Load New Filament

[0hCome0n]

Firmware Version 1.1.46

Pretty self-explanatory. You hear it clicking against the end of the filament as you push it in and the loader pushes it out. Reverting to 1.1.25 fixed issue.

[flukejones]

I just experienced this. Very very annoying. Turning printer off then on fixed it for now.

[0hCome0n]

I will try that next time if I decide to switch back to 1.1.46

[0hCome0n]

Issue persists in 1.1.46 (I tried switching back to fix a freeze issue)

The issue will show up randomly and be fixed by a restart. This has caused failures in multi-material prints where I need to perform a filament change and discover the loading spins backwards.

[0hCome0n]

To be honest, I think Elegoo created this github to give people a place to complain, not to actually fix any of the issues.