Arduino and ADXL362 bad values

[rivasakin]

Hello, I try to connect my ADXL362 with my ARDUINO Mega 2560 on SPI.
I've connected the ADXL362 trough a Logic Level Shifter, 4-Channel, Bidirectional to the Arduino and when I try the SampleRead code, I can just see the XValue. YValue, ZValue and temperature still stay at "-1".
My code is :
`/*
ADXL362_SimpleRead.ino - Simple XYZ axis reading example
for Analog Devices ADXL362 - Micropower 3-axis accelerometer
go to http://www.analog.com/ADXL362 for datasheet

License: CC BY-SA 3.0: Creative Commons Share-alike 3.0. Feel free
to use and abuse this code however you'd like. If you find it useful
please attribute, and SHARE-ALIKE!

Created June 2012
by Anne Mahaffey - hosted on http://annem.github.com/ADXL362

Modified May 2013
by Jonathan Ruiz de Garibay

Connect SCLK, MISO, MOSI, and CSB of ADXL362 to
SCLK, MISO, MOSI, and DP 10 of Arduino
(check http://arduino.cc/en/Reference/SPI for details)

*/

#include <SPI.h>
#include <ADXL362.h>

ADXL362 xl;

int16_t temp;
int16_t XValue, YValue, ZValue, Temperature;

void setup(){

Serial.begin(9600);
xl.begin(53); // Setup SPI protocol, issue device soft reset
xl.beginMeasure(); // Switch ADXL362 to measure mode

Serial.println("Start Demo: Simple Read");
}

void loop(){

// read all three axis in burst to ensure all measurements correspond to same sample time
xl.readXYZTData(XValue, YValue, ZValue, Temperature);
Serial.print("XVALUE=");
Serial.print(XValue);
Serial.print("\tYVALUE=");
Serial.print(YValue);
Serial.print("\tZVALUE=");
Serial.print(ZValue);
Serial.print("\tTEMPERATURE=");
Serial.println(Temperature);
delay(100); // Arbitrary delay to make serial monitor easier to observe
}
`

I can see on the serial this :

If you can see, this is how I Have connected my ADXL362 :

Can you help me please ??!!

Thanks a lot