Boot loop on Wyze cam 2

[xdissent]

I'm running openfang master (695670d) on a Wyze Cam 2 and this check is sending it into a boot loop. On my camera, the reset button gpio (pin 50) is always 0 at this point in the boot process, regardless of whether I'm pressing it or not. I don't know if it's looking at the wrong pin or what, but my camera always clears rtdev nvram and reboots, flip flopping between factory reset mode and this check. Disabling the check lets me boot fine.

[xdissent]

I think this is the behavior #51 describes

[anmaped]

@xdissent Did you flash the compiled openfang bootloader?

[xdissent]

Yes, a compiled openfang bootloader (from master, built in docker locally) has been flashed.

[tachang]

@xdissent When you compiled and flashed the bootloader how large was the file? Is there a reason you didn't use the released one?