The underfill solution with holes and toolpath compensation.

[Bo-Ru-Tseng]

Hi,
I have some questions about the underfill solution with holes inside.
I followed the ReadMe.pdf to try the examples of "demo_tool_compensate" and "demo_underfill" and tried to integrate them.
However, I found that the path to the outer of the hole doesn't conduct toolpath compensation. Can I ask for this problem some hints or advice?
sincerely appreciate

[WangY18]

Hi Bo-Ru-Tseng! Thanks for your attention!

I am sorry that I may not have fully understood what you mean without figure and code. You can provide them if possible. Some generic suggestions are as follows.

• Given a slice, we can firstly use tool_compensate to obtain the "real slice for planning toolpaths". After planning toolpaths, we compare the toolpaths and the original slice (which is not compensated) for the underfill distribution.
• Therefore, we usually need two NEPathPlanner in total. The original one (before tool compensating) is for computating underfills. The compensated one is for planning toolpaths. The above method can be observed in demo_tool_compensate.

If you need more hints, please provide some further information. Thank you again for your attention!