the "Enable Sensor" checkbox seems to have no impact; if I uncheck it, my prints still get paused.
Additionally, if I set the plugin to "distance detection", it seems to trigger after just a few seconds, even though the filament is present and moving just fine. Detection distance is set to 15mm, though I tried 100 and 1000mm and it didn't seem to make a difference.
If I set it to "timeout", it does a similar thing, though if I set the "detection time" to "100 seconds" it seems to work (so far anyways).
User error? A bug? Something else?
Am running a BTT sensor connected to RPI GPIO pin 11 off 3.3v.
the "Enable Sensor" checkbox seems to have no impact; if I uncheck it, my prints still get paused.
Additionally, if I set the plugin to "distance detection", it seems to trigger after just a few seconds, even though the filament is present and moving just fine. Detection distance is set to 15mm, though I tried 100 and 1000mm and it didn't seem to make a difference.
If I set it to "timeout", it does a similar thing, though if I set the "detection time" to "100 seconds" it seems to work (so far anyways).
User error? A bug? Something else?
Am running a BTT sensor connected to RPI GPIO pin 11 off 3.3v.