Updated my QUIDI Max 3 to the latest firmware and lo and behold NOTHING is working. I keep getting bedmesh errors and no trigger on probe after full movement errors. It was working fine until i updated to the "latest" and not so greatest. The nozzle keeps going to the extreme right hand side and it starts chewing itself up. the belts sound like they are going to disintegrate. Why is this happening? I have done a factory reset which has calmed it down a little, however, it still runs into the extreme right hand side and throws the probe movement error.
Updated my QUIDI Max 3 to the latest firmware and lo and behold NOTHING is working. I keep getting bedmesh errors and no trigger on probe after full movement errors. It was working fine until i updated to the "latest" and not so greatest. The nozzle keeps going to the extreme right hand side and it starts chewing itself up. the belts sound like they are going to disintegrate. Why is this happening? I have done a factory reset which has calmed it down a little, however, it still runs into the extreme right hand side and throws the probe movement error.