Bikecontrol 6.3.0+13 TPV 'No Signal'

[meta-l]

Morning,

After your recommendation to move it to network, I got it working ok, but since then, I've always had the 'No Signal' Error.

I have tried disconnecting it, unpairing it, disabling network mode on BikeControl, but always comes back to 'No signal'. Can you advise please as to what I might be doing incorrectly?

[jonasbark]

It might just be badly represented in TrainingPeaks. Can you confirm it to be working otherwise? I'll follow up with them.

[meta-l]

From what I recall of this morning's session, left and right worked, and gear change, until I engaged ERG mode for the session. However, in a session last week and this morning, the controllers disconnected midway through the session (on world route and ERG, so there was no gear changing or steering needed). I heard a chime from windows and also the Zwift buttons started flashing like they do before they are connected. It didn't matter a huge amount, as I needed no input, but I was a little apprehensive as to why, especially after swapping it to network mode (which worked perfectly the first time). Could it be that because TPV is showing no signal it shut down?