DS18B20 cannot be assigned to any valve

[malloderfloh]

Hi Developers,

thank you for your great project.

Some time ago, I purchased one of your kits and was able to get everything up and running successfully.

Currently, I am trying to assign one or more DS18B20 sensors to the corresponding valves, but I have not been able to make it work.

The valve is detected correctly, calibrated successfully, and can also be controlled via MQTT. A connected DS18B20 sensor is detected on the CONFIG page after a scan and continuously provides valid readings according to the STATUS page. However, I am unable to assign the sensor to the valve.

After configuring the assignment on the CONFIG page and saving the settings, the system reboots and then shows "failed" on the STATUS page.

I have already tested several different DS18B20 sensors, both individually and multiple sensors at the same time, with and without a pull-up resistor.

Could you please help me troubleshoot this issue?

WT32: SW Version 1.3.7_Dev build 13.07.2024 10:10
STM32: 1.3.7_Dev_C2 build 13.07.2024 10:24

Thank you very much for your support.

Best regards,
Manuel

[SurfGargano]

Hi Manuel,
The software developement is moved to SurfGargano.

Please try the latest version. You will find the latest version here : https://github.com/SurfGargano/VdMot_Controller/releases/latest

best regards Werner