Framework 16 laptop touchpaad file is wrong size.

[Darth-Ambiv-Revan]

The original version is the correct length, and it fits, but the updated version with improved clips is around a millimeter or so larger and bows upwards in the laptop.

I am talking about the one-piece 3d file that is up specifically by the way.

[xamindar]

You should ensure your printer is properly calibrated. If it is not, it will print things in the incorrect size. Best way to do this is to look up a calibration cube and print it. Usually it's a 20x20x20mm cube. Measure it with calipers and make sure each side matches 20mm. If not, adjust your printer as needed.

I have printed two of these and they both fit perfectly.