Runcam Thumb

[tomstom]

Good Morning,

I had the chance to look on the files of the new Runcam Thumb. And I have to say it was not possible to get it stabilzed by Version 1.0. But with version 0.3 it was better but not Ok...

The problem:

• The Gyrodata has an offset
• The Gyrodata is to slow

In numbers approx:

factorX = 1.0 #Y in Gyroflow
offsetX = 392 #Y
factorY = 1.0 #X in Gyroflow
offsetY = 400 #X
factorZ = 1.0
offsetZ = 100
2.225s/1min Video to slow

The link to the files: https://www.dropbox.com/s/z3gdv271uhjdlbz/Painless360%20RunCam%20Thumb%20files%20for%20GyroFlow.zip?dl=0
(Posted by Painless360 in the comments of the Video: https://www.youtube.com/watch?v=NEalIp1KBBM)

[fa-lk]

As temporary fix, you can right click on the gyrodata in gyroflow at a time where the Thumb was hold still and let gyroflow roughly calculate the gyro-offsets.

A solution from runcam / more possibilities to correct data in gyroflow would both be nice :)