|
I have recently flashed my Horus x10x express with OpenTx to EdgeTx. I still have a few models from OpenTx that I want to put on EdgeTx. Will EdgeTx convert them over or will I have to Re-flash the x10s with Edge to get converted? |
Replies: 1 comment 3 replies
|
You only need to open the *.otx file in the EdgeTX Companion, you will be asked if you want to convert the file. |
|
Hope you can see this, I just did the migration, I have the .otx file, but I'm unable to open it in EdgeTX Companion (v2.11.0), when trying to open a file I don't have the option to open an OTX file in the Open file Dialog |
|
Companion 2.10 is the last version to support reading otx files. By default multiple Companion versions can be installed side by side. So install v2.10.6 read the otx files and write as etx. Then the etx files can be read by v2.11. |
|
Thank you so much! I was thinking something like this but no clue which version, just did what you suggested and I have the models in the radio already |
You only need to open the *.otx file in the EdgeTX Companion, you will be asked if you want to convert the file.