Tuning errors?

[IngwiePhoenix]

Hello!

I just finished building this from source on Alpine for my Raspberry Pi 3 and while popping into VLC to just do a quick little test, I saw this in the logs:

  Sun Jul 12 11:07:43.1746 2026  6  Frontend: 1, Opened /dev/dvb/adapter0/frontend0 for Writing DiSEqC command with fd: 15
  Sun Jul 12 11:07:43.3788 2026  3  FE_ENABLE_HIGH_LNB_VOLTAGE failed to switch off: No error information (code 524)
  Sun Jul 12 11:07:43.3789 2026  7  Frontend: 1, Using LNB with: Lof-High=10600 MHz  Lof-Low=9750 MHz  Lof-Switch=11700 MHz -> IF=1611 MHz
  Sun Jul 12 11:07:43.3789 2026  6  Frontend: 1, Sending LNB: Mini-Switch Src: 0
  Sun Jul 12 11:07:43.5954 2026  7  Frontend: 1, Set Properties: Frequency 1611750
  Sun Jul 12 11:07:43.5954 2026  7  Frontend: 1, Set Properties: PLS Mode 1
  Sun Jul 12 11:07:43.5955 2026  7  Frontend: 1, Set Properties: PLS Code 0
  Sun Jul 12 11:07:43.5956 2026  6  Frontend: 1, Tuned, waiting on lock...
  Sun Jul 12 11:07:44.0464 2026  6  Frontend: 1, Not locked yet   (FE status 0x00)...
`` 

Is that just my VLC sending a bad request or me? I used the same adapter for a long time behind TVHeadend, but decided that I wanted to move TVH onto more powerful hardware, and thus running this now instead.

The device is idenfified as "Montage Technology M88DS3103B".

Thanks!

[Barracuda09]

You mean the FE_ENABLE_HIGH_LNB_VOLTAGE error?

[IngwiePhoenix]

Yes, exactly.

[Barracuda09]

Most likely it is not supported by this tuner.

Does it not correctly tune then?